Cobalt L4-2.4L VIN B (2006)
1. With the bearing hub still in position, install the NEW stud into the bearing/hub assembly.
2. Add enough washers (1) in order to draw the stud into the hub.
3. Install the wheel nut (2) with the flat side against the washers.
4. Tighten the wheel nut until the head of the wheel stud is fully seated against the back of the bearing hub flange.
5. Remove the wheel nut and the washers.
6. Install the brake rotor, and install the brake caliper and bracket as an assembly.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
Wheel Stud Replacement (5-Stud Pattern)
Wheel Stud Replacement (5-Stud Pattern)
^
Tools Required
-
J 43631 Ball Joint Remover
Removal Procedure
