Cobalt L4-2.4L VIN B (2006)
3. If equipped with RPO LSJ, perform the following steps, install the positive battery cable terminal (2) to the starter solenoid.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the starter solenoid terminal nut (3).
^
Tighten the nut to 17 Nm (13 ft. lbs.).
5. If equipped with RPOs L61 or LE5, perform the following steps, Install the positive battery cable terminal (3) to the starter solenoid.
6. Install the starter solenoid terminal nut (4).
^
Tighten the nut to 17 Nm (13 ft. lbs.).
7. Lower the vehicle.
