Cobalt L4-2.4L VIN B (2006)
8. Remove the connector position assurance (CPA) from the seat belt retractor pretensioner - LF connector.
9. Disconnect the seat belt retractor pretensioner - LF connector from the vehicle harness connector.
10. Remove the garnish molding from the upper lock pillar.
11. Remove the CPA from the roof rail module - left connector.
12. Disconnect the roof rail module - left connector from the vehicle harness connector.
13. Remove the LH door trim panel.
14. Peel back the door water deflector far enough to access the SIS - left.
15. Remove the CPA from the SIS connector.
16. Disconnect the SIS connector from the SIS - left.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the SIS - left, go to step 3. To enable the roof rail module - left, go to step 7, and to enable the seat belt retractor pretensioner - LF, go to
step 10.