Cobalt L4-2.4L VIN B (2006)
2. Apply grease from the service kit to the indicated locations.
Important: The boot must seat in the groove in the steering gear.
3. Install the boot over the inner tie rod onto the steering gear.
4. Using the J 22610, crimp the inner boot clamp on the steering gear housing.
5. Install the small spring clamp on the outer portion of the inner tie rod end.
6. Install a new outer to inner tie rod jam nut.
7. Install the outer tie rod end.
8. Install the wheel.
9. Set the toe. Refer to Front Toe Adjustment.
