Cobalt L4-2.4L VIN B (2006)
10. Align the left side axle bracket and snug down the bolts.
11. Align the right side axle bracket and snug down the bolts.
12. Tighten all the bracket to body bolts.
Tighten the bolts to 90 Nm (66 lb ft) + 45 degrees.
13. Install the wheel bearing/hubs, with the brakes and backing plate assemblies.
14. Install the bearing/hub nuts.
Tighten the nuts to 45 Nm + 30 degrees (33 lb ft + 30 degrees).
15. Connect the brake hoses to the rear axle brackets.
16. Connect the brake pipes to the brake hoses at the axle.
Tighten the brake pipe fittings to 19 Nm (14 lb ft).
17. Install the rear coil springs.
18. Install the lower shock bolts.
19. Lower and remove the hydraulic lift table.
20. If applicable, connect the ABS sensor harness connector and harness to axle retainer.
21. Connect the park brake cables to the axle brackets and rear brakes.
22. Bleed the brake system.
23. Install the rear wheels.
24. Lower the vehicle.
