Cobalt L4-2.4L VIN B (2006)
5. Remove the strut lower bolts, nuts and antilock brake system (ABS) wiring bracket, if equipped.
6. Remove the strut.
Installation Procedure
1. Install the strut.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the strut upper mounting nuts.
^
Tighten the nuts to 20 Nm (15 ft. lbs.).
Important: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
^
The fastener and its counterpart are clean and free from rust.
^
The fastener develops 3 Nm (27 inch lbs.) of torque/drag against its counterpart prior to the fastener seating.
3. If the fastener does not meet these criteria, REPLACE the fastener. Install the strut lower bolts, nuts and ABS wiring bracket, if equipped.
^
Tighten the strut lower nuts to 120 Nm (89 ft. lbs.).
