Cobalt L4-2.4L VIN B (2006)
Seals and Gaskets: Service and Repair
Case Side Cover Seal Replacement
Case Side Cover Seal Replacement
^
Tools Required
-
J 41227 Output Shaft Sleeve Remover
-
J 41228 Output Shaft Seal Installer
-
J 41102 Axle Seal Installer
Removal Procedure
1. Caution: Refer to Vehicle Lifting Caution in Service Precautions.
Raise the vehicle.
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement.
3. Use a medium screwdriver and a mallet in order to remove the case cover seal.
4. Remove the drive axle retaining clip from the output axle.
5. Use the J 41227 in order to remove the sleeve from the output axle shaft.
6. Clean and inspect the seal bore.
7. Use fine sand paper in order to remove any burrs or nicks. Clean the entire area after any sanding.
Installation Procedure
