Cobalt L4-2.4L VIN B (2006)
24. Mount DT-47732 in a vise and proceed as follows:
1. Position the outboard end (1) of the wheel drive shaft assembly in tool.
2. Align the top of boot neck on the bottom die using the indicator.
3. Place the top half of the DT-47732 on the lower half of the DT-47732.
4. Before proceeding, ensure there are no pinch points on the boot. This could cause damage to the boot.
5. Insert the bolts (2).
6. Tighten the bolts by hand until snug.
Notice: Refer to Fastener Notice in Service Precautions.
25. Align the following items:
^
The shaft out board boot (1)
^
The shaft boot grooves
