Cobalt L4-2.4L VIN B (2006)
3. Mount DT-47732 in a vise and proceed as follows:
1. Position the inboard end (1) of the wheel driveshaft assembly in tool DT-47732.
2. Align the top of boot neck on the bottom die using the indicator.
3. Place the top half of tool DT-47732 on the lower half of tool.
4. Before proceeding, ensure there are no pinch points on the wheel driveshaft inboard boot. This could cause damage to the inboard boot.
5. Insert the bolts (2).
6. Tighten the bolts by hand until snug.
Notice: Refer to Fastener Notice in Service Precautions.
4. Align the following items:
^
The inboard boot (1)
^
The shaft boot grooves
