Colorado 2WD L4-2.8L VIN 8 (2004)
Compressor Clutch Hub: Service and Repair
COMPRESSOR CLUTCH PLATE/HUB ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Remove the compressor.
2. Remove the clutch plate retaining bolt (1).
3. Remove the clutch plate assembly (2).
4. Remove the clutch hub/bearing snap ring (3).
5. Remove the clutch hub/bearing assembly (4).
INSTALLATION PROCEDURE
1. Install the clutch hub/bearing assembly (4).
2. Install the clutch hub/bearing snap ring (3).
3. Install the clutch plate assembly (2).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the clutch plate retaining bolt (1).
Tighten
Tighten the bolt to 18 N.m (13 lb ft).
5. Install the compressor.