Colorado 2WD L4-2.8L VIN 8 (2004)
Fuel Pressure: Testing and Inspection
Fuel Pressure Gage Installation and Removal
FUEL PRESSURE GAGE INSTALLATION AND REMOVAL
INSTALLATION PROCEDURE
Tools Required
-
J 34730-1A Fuel Pressure Gage
-
J 42242 Fuel Pressure Gage Adapter
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.
NOTE: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
-
The fuel pipe connections
-
The hose connections
-
The areas surrounding the connections
1. Remove the cap on the fuel pressure service connection.
CAUTION: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will
absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the
connection of the fuel pressure gage is complete.
2. Connect the J 42242 (1) and the J 34730-1A (2) to the fuel pressure service connection. Wrap a shop towel around the fitting while connecting the
gauge to avoid spillage.
3. Turn the ignition ON, with the engine OFF.
CAUTION: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an
explosion.
4. Place the bleed hose of the J 34730-1A (2) into an approved gasoline container.
5. Open the bleed valve on the J 34730-1A (2) in order to bleed the air from the fuel pressure gage.
6. Command the fuel pump ON with a scan tool.
7. Close the bleed valve on the J 34730-1A (2).
8. Inspect for fuel leaks.
REMOVAL PROCEDURE
1. Ensure the fuel pump is OFF