Colorado 2WD L4-2.8L VIN 8 (2004)
2. If installing the original steering wheel perform the following:
2.1.
Position the steering wheel to the steering column.
2.2.
Align the marks made during the removal of the steering wheel.
3. Push the steering wheel onto the steering shaft.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the steering wheel nut (2) to the steering shaft.
^
Tighten the nut to 35 Nm (26 ft. lbs.).
5. Unlock the steering column by removing the J 421540 from the lower trim cover access hole.
6. Install the inflator module.
7. Enable the SIR system.
