Colorado 2WD L4-2.8L VIN 8 (2004)
Transmission Pressure Test Port: Service and Repair
Oil Pressure Test Plug Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the oil pressure test plug.
Installation Procedure
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
1. Install a oil pressure test plug.
^
Tighten the oil pressure test plug to 8 Nm (71 inch lbs.).
2. Check the transmission fluid level (fill if necessary).
3. Lower the vehicle.
