Colorado 2WD L4-2.8L VIN 8 (2004)
3. Remove the 4 nuts securing the clutch pedal assembly to the cowl.
4. Remove the clutch pedal assembly from the vehicle.
Installation Procedure
1. Position the clutch pedal assembly over the studs.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the clutch pedal assembly nuts.
^
Tighten the clutch pedal assembly nuts to 20 Nm (15 ft. lbs.).
3. Insert a new retainer (3) into the clutch master cylinder push rod (1).
4. Push the clutch master cylinder push rod (1) onto the clutch pedal pin to secure.