Colorado 2WD L5-3.5L VIN 6 (2005)
2. Connect the roof rail module connector (1) and install the garnish molding.
3. Connect the seat belt pretensioner - left and install the CPA.
4. Install the trim panel.
5. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
7. Install the left door trim panel.
8. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
9. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
10. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
