Colorado 2WD L5-3.5L VIN 6 (2005)
1. Lubricate the oil filter seal with clean engine oil.
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Install the new oil filter.
^
Tighten the oil filter to 30 Nm (22 ft. lbs.).
3. Wipe the excess oil from the oil filter drain deflector.
4. Install the oil pan drain plug.
^
Tighten the oil pan drain plug to 26 Nm (19 ft. lbs.).
5. Lower the vehicle.
6. Fill the crankcase with the proper type and amount of engine oil.
7. Install the oil fill cap.
8. Start the engine and inspect the oil pressure gage for appropriate pressure build up.
9. Shut the engine off.
10. Inspect the oil filter and oil pan drain plug areas for leaks.
11. Remove the oil level indicator and inspect for proper oil level. Adjust if necessary.
