Colorado 2WD L5-3.5L VIN 6 (2005)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Oil Seal Replacement
Crankshaft Rear Oil Seal Replacement
^
Tools Required
-
J 8092 Driver Handle
-
J 44215 Rear Seal Installer
Removal Procedure
1. Remove the flywheel.
Important: Do not damage the crankshaft or seal bore.
2. Using a suitable tool, pry the crankshaft rear oil seal from the crankshaft rear oil seal housing. Discard the seal.
Installation Procedure
1. Lightly lubricate the crankshaft rear oil seal lip with clean engine oil.
2. Position the plastic installation sleeve supplied with the new seal to the crankshaft.
3. Use the J 44215 with the J 8092 and a hammer to install the crankshaft rear oil seal into the crankshaft rear oil seal housing.
^
The spring side of the seal goes toward the engine
^
Ensure the seal is installed square
^
The seal will bottom out in the housing when fully installed
4. Install the flywheel.
