chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Engine, A/T - Shift/Driveability Concerns/MIL ON|Page 1087 > < Engine, A/T - Shift/Driveability Concerns/MIL ON|Page 1085
Page 2
background image

3.

Set the inflation per the vehicle tire placard located on the driver's door.

Important:

On 2WD models, DO NOT replace the front coil spring(s) or add insulators to compensate for a low trim Z height. A lower trim Z height
reading is acceptable as long as it is within specification. Refer to Trim Height Inspection Procedure.

4.

Check and adjust the vehicle Z height. 

Important:

ON 2WD models, ONLY replace the front coil spring(s) if the trim Z height is too low and out of specification.

5.

ON 2WD models, ONLY replace the front coil spring(s) if the trim Z height is too low and out of specification. 

6.

Check and adjust the vehicle front toe to 0.00° +/- 0.20°.

7.

Road test the vehicle in order to verify that the steering wheel is straight.

Warranty Information

For vehicles repaired under warranty, use the table.

Disclaimer

Technical Service Bulletin # 04-03-07-004B

Date: 050722

Steering/Suspension - Front Tires Wear Prematurely

Bulletin No.: 04-03-07-004B

Date: July 22, 2005

TECHNICAL

Subject:
Premature Front Tire Wear (Set Front Z Height, Toe and Rotate or Replace Front Tires)

Models:
2004-2005 Chevrolet Colorado
2004-2005 GMC Canyon

Built Prior to November 18, 2004

Supercede:

This bulletin is being revised to add a build date to the Models. Please discard Corporate Bulletin Number 04-03-07-004A (Section 03 - Suspension).

Engine, A/T - Shift/Driveability Concerns/MIL ON|Page 1087 > < Engine, A/T - Shift/Driveability Concerns/MIL ON|Page 1085