Colorado 2WD L5-3.5L VIN 6 (2005)
threads. If you remove an oxygen sensor and if for any reason you must install the same oxygen sensor, apply the anti-seize compound to the threads
before reinstallation.
1. Coat the threads of the HO2S with the anti-seize compound P/N 5613695, or equivalent if necessary.
2. Using the J 39194-B , install the HO2S into the exhaust manifold.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
Tighten the HO2S to 42 N.m (31 lb ft).
3. Connect the HO2S electrical connector (5) to the following:
-
The engine wiring harness electrical connector
-
The camshaft cover