Colorado 2WD L5-3.5L VIN 6 (2005)
6. Install the wheel bearing/hub, brake rotor assembly in the steering knuckle.
7. Align the wheel speed sensor wiring harness with the reference mark on the steering knuckle.
Important: When performing the following service procedure, DO NOT use air tools of any type to torque the brake rotor to hub bolts.
8. Install the wheel bearing/hub, brake rotor mounting bolts.
^
Tighten the mounting bolts to 125 Nm (92 ft. lbs.).
9. Install the brake caliper mounting bracket to the steering knuckle.
