Colorado 2WD L5-3.5L VIN 6 (2005)
4. Position the J 41364-A onto the park/neutral back up switch. Ensure that the 2 slots on the switch where the manual shaft is inserted are lined up
with the lower 2 tabs on the tool.
5. Notice: Refer to Fastener Notice in Service Precautions.
Rotate the switch until the upper locator pin on the tool is lined up with the slot on the top of the switch.
Tighten the park/neutral back up switch bolts 27 Nm (20 ft. lbs.).
6. Remove the J 41364-A from the switch. If installing a new switch, remove the positive assurance bracket at this time.
7. Connect the electrical connector (3) to the switch (4).