Colorado 2WD L5-3.5L VIN 6 (2005)
2. Important: Ensure the seal does not catch on the input shaft splines.
Position the input shaft bearing retainer to the transmission.
3. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the input shaft bearing retainer bolts if new bolts are not
available.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the NEW input shaft bearing retainer bolts.
Tighten the input shaft bearing retainer bolts to 17 Nm (13 ft. lbs.).
5. Install the clutch actuator cylinder.
6. Fill the transmission fluid.
