Colorado 2WD L5-3.7L (2007)
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
1. Apply tape to the area around the tailgate emblem.
2. Heat the emblem/nameplate, using a J 25070, 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice.
4. Remove the emblem/nameplate from the tailgate surface using a plastic, flat-bladed tool.
5. Remove all adhesive from the tailgate panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover
disk 3M(TM) P/N 07501 or equivalent.
6. Clean the tailgate surface using varnish makers and painters (VMP) naphtha.
Installation Procedure
1. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
*
Dimension (a) is 61 mm (2.4 in) from the edge of the tailgate to the emblem/nameplate.
*
Dimension (b) is 66.4 mm (2.61 in) from the bottom of the tailgate to the emblem/nameplate.
2. Warm the tailgate surface with a J 25070, 152 mm (6 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
