Colorado 2WD V8-5.3L (2009)
7. Using your finger, remove the socket retaining ring by pulling the retaining ring out of the mounting hole.
Installation Procedure
1. Position the retaining ring to the mounting hole.
2. Index the key to the retaining ring to the slot in the mounting hole.
3. Install the retaining ring by pressing the retaining ring into the mounting hole until fully seated.
4. Connect the electrical connector to the socket.
5. Position the socket to the retaining ring.
6. Install the socket into the retaining ring by pressing in the socket until fully seated.
7. Install the 12 volt power supply or cigar lighter fuse.
