Colorado 2WD V8-5.3L (2009)
2. Connect the electrical connector (2) to the SDM (1).
3. Fold the carpet back down over the SDM.
4. Install the floor console. Refer to Console Replacement (Large w/Manual or Auto Transmission) (See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair)Console Replacement (Small w/Manual Transmission) (See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair).
Note: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in
multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly
to ensure that the SDM is set properly.
5. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair).
6. Program the SDM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
