Colorado 2WD V8-5.3L (2009)
Note: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the
boot.
1. Install the stabilizer shaft link.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the stabilizer shaft link mounting nuts.
*
Tighten the stabilizer bar link lower mounting nut to 44 Nm (32 lb ft).
*
Tighten the stabilizer bar link upper mounting nut to 44 Nm (32 lb ft).
3. Remove the axle support.
4. Lower the vehicle.
