Colorado 2WD V8-5.3L (2009)
1. Install the clutch pressure plate (2) and driven plate (3) to the dowel pins (4) on the flywheel (5).
2. Install the clutch pressure plate bolts (1) finger tight.
3. Use the Snap-On A145 Clutch Aligner Set, or equivalent, to align the clutch driven plate (3) to the clutch pilot bearing.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the NEW clutch pressure plate bolts in the sequence shown.
1. Tighten the clutch pressure plate bolts in sequence to 20 Nm (15 lb ft).
2. Use the J 36660-A in order to tighten the clutch pressure plate bolts in sequence an additional 45 degrees.
5. Install the transmission. Refer to Transmission Replacement (4WD) (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transmission Replacement)Transmission Replacement (RWD) (See: Manual Transmission/Transaxle/Service and Repair/Removal
and Replacement/Transmission Replacement).
