Colorado 2WD V8-5.3L (2009)
Note: Failure to align the reference marks properly will cause a vibration the propeller shaft.
4. Position the yoke on the propeller shaft so that the reference marks are aligned properly.
5. Using a brass or hard rubber hammer, lightly tap the yoke on the propeller shaft.
6. Install the washer.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Tighten the retaining nut by hand before tightening the retaining nut to the proper specifications.
7. Install the retaining nut and tighten to 167 Nm (123 lb ft).