Colorado 2WD V8-5.3L (2009)
5. Disconnect the electrical connector from the window regulator motor, if equipped with A31.
6. Loosen the bolts (1) retaining the window regulator to the inner panel at the keyhole slot locations.
7. Remove the remaining fasteners retaining the window regulator to the inner panel.
8. Remove the window regulator from the door by lifting the regulator up, and out of the keyhole slots, and removing the regulator out through the
access hole.
Installation Procedure
1. Install the front door window regulator into the front door through the access hole.
2. Position the window regulator to the inner panel by sliding the regulator bolts (1) into the keyhole slots in the inner panel.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the fastener retaining the front door window regulator to the door. Tighten the front window regulator fasteners to 9 Nm (80 lb in).
4. Connect the electrical connector to the window regulator motor, if equipped with A31.
