Colorado 4WD L4-2.9L (2008)
1. Position the wheel speed sensor on the wheel hub/bearing assembly.
2. Carefully press the wheel speed sensor squarely onto the wheel hub/bearing assembly until fully seated against the lip of the wheel hub/bearing
assembly housing.
Important: Align the wheel speed sensor harness with the reference mark on the steering knuckle.
3. Install the wheel hub/bearing and brake rotor assembly (2) to the steering knuckle (3) with the wheel speed sensor harness positioned upward.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the wheel hub/bearing bolts (1).
Ensure the wheel speed sensor harness is positioned upward.
Tighten the bolts to 125 N.m (92 lb ft).
