Colorado 4WD L4-2.9L (2008)
6. Remove and discard the intake camshaft sprocket bolt.
7. Remove the intake camshaft sprocket.
Installation Procedure
1. Install the intake camshaft sprocket into the timing chain.
Aligning the marked link (1) on the timing chain with the timing mark on the intake camshaft sprocket.
Important:
*
To aid in aligning the sprocket to the camshaft, use a 25 mm (1 in) wrench on the hex of the camshaft to rotate.
*
Ensure the alignment pin is properly engaged with the camshaft.
2. Install the intake camshaft sprocket onto the intake camshaft.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the new intake camshaft sprocket bolt.
Tighten the intake camshaft sprocket bolt to 20 N.m (15 lb ft) plus an additional 100 degrees using the J 45059 .
