Colorado 4WD L4-2.9L (2008)
3. Install the 2 fasteners retaining the BCM to the hinge pillar.
4. Install the fastener retaining the body wiring harness electrical connector to the BCM.
5. Connect the body wiring harness electrical connector (1) to the BCM.
6. Connect the I/P wiring harness electrical connector (1) to the BCM.
7. Install the right front hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side (See: Body and Frame/Interior
Moulding / Trim/Trim Panel/Service and Repair) .
8. If installing a replacement BCM, program the BCM. Refer to Control Module References (See: Testing and Inspection/Programming and