Colorado 4WD L4-2.9L (2008)
Transfer Case Actuator: Service and Repair
Transfer Case Encoder Motor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Disconnect the following from the encoder motor (7):
*
The electrical connector (8)
*
The vent hose
3. Remove the encoder motor mounting bolts.
4. Remove the encoder motor (3) and O-ring seal (2) from the transfer case.
Discard the O-ring seal (2).
Installation Procedure
Important:
*
The actuator shaft in the transfer case may require rotating to the neutral position prior to installing the encoder motor.
*
Do not rotate the actuator shaft using the encoder motor.
