Colorado 4WD L4-2.9L (2008)
1. Lightly lubricate the O-ring seal (1).
2. Position the O-ring seal (1) to the speed sensor (2), if removed.
Notice: Refer to Component Fastener Tightening Notice (See: Service Precautions/Vehicle Damage Warnings/Component Fastener Tightening
Notice) .
3. Install the speed sensor (2) into the transfer case.
Tighten the speed sensor to 17 N.m (13 lb ft).
4. Connect the electrical connector (3) to the transfer case speed sensor (2).
5. Lower the vehicle.
