Colorado 4WD L4-2.9L (2008)
3. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the steering knuckle.
4. Remove the wheel hub/bearing bolts (1).
5. Remove the brake rotor (2) and the wheel hub/bearing as an assembly from the steering knuckle (3) while routing the wheel speed sensor harness
through the steering knuckle.
Important: Note that the wheel speed sensor harness is positioned at the narrowest span between the wheel hub/bearing bolt holes.
6. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the wheel hub/bearing assembly.
Important: DO NOT lever or pry against the wheel speed sensor tone wheel under the wheel speed sensor. Lever against the wheel hub
ONLY.
7. Using a suitable tool, pry or lever the wheel speed sensor off of the wheel hub/bearing housing.
Discard the wheel speed sensor.
Installation Procedure
Important: Align the wheel speed sensor harness with the reference mark on the wheel hub/bearing assembly between the bolt holes
narrowest span.
