Colorado 4WD L4-2.9L (2008)
Installation Procedure
1. Assemble the control lever housing if previously disassembled. Refer to Shift Control Housing Assemble (See: Service and
Repair/Overhaul/Assembly/Shift Control Housing Assemble) .
2. Remove the masking from the control lever opening and ensure the sealing surface is clean and dry.
3. Place the control lever gasket on to the transmission.
4. Position the control lever housing assembly to the control lever assembly opening, aligning the bushing with the internal shift control lever.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Install the control lever housing assembly bolts.
Tighten the control lever assembly bolts to 20 N.m (15 lb ft).
6. Slide the boot into position over the control lever.
Important: Ensure the carpet is not between the boot and the floor panel.
7. Tilt the boot in order to seat to the floor.
8. Install the control lever boot screws.
