Colorado 4WD L5-3.5L VIN 6 (2005)
For vehicles repaired under warranty, use the table.
Disclaimer
Technical Service Bulletin # 05-08-64-018
Date: 050614
Interior - Center of Door Trim Panel Loose
Bulletin No.: 05-08-64-018
Date: June 14, 2005
TECHNICAL
Subject:
Door Trim Loose In Center of Door (Install Two Rivets Into Pull Handle Bracket)
Models:
2005 Chevrolet Colorado
2005 GMC Canyon
Condition
Some customers may comment that the driver door trim is loose.
Cause
This condition may be caused by the two spot welds coming loose on the door pull bracket.
Correction
Secure the door pull bracket to the door by installing rivets. Follow the procedure below.
1.
For vehicles equipped with manual windows, remove the window regulator handle from the door by inserting tool J 09886-A between the handle
and the plastic washer to remove the retaining clip.
2.
Remove the retaining screw from the door handle bezel.
3.
Remove the bezel.
4.
Remove the two screws securing the switch plate assembly to the door.
5.
Lift the front of the plate up to disengage the clip tower.
6.
Disconnect the electrical harness from the power mirror, window and lock switch if equipped.
7.
Remove the switch plate assembly.
8.
Gently pull the door panel away from the door.
9.
Drill two 1/4 inch holes through the bracket and the door.
10.
Apply Synthetic Lubricant with Teflon to the holes to help prevent corrosion.