Colorado 4WD L5-3.5L VIN 6 (2005)
6. Install the ABS module to the vehicle.
7. Install mounting nuts for the ABS module.
^
Tighten the mounting nuts to 9 Nm (80 inch lbs.).
8. Remove the rubber plugs from the brake pipes.
9. Remove the shipping plugs from the EBCM assembly.
10. Install the brakes pipes to the EBCM assembly.
^
Tighten all the brake pipe fittings to 19 Nm (14 ft. lbs.).
Important: When installing the brake pipe fitting, always finger tighten the fitting before torquing to the proper torque specification.
