Colorado 4WD L5-3.5L VIN 6 (2005)
1. Install the brake line to the brake hose.
^
Tighten the mounting bolt to 19 Nm (14 ft. lbs.).
2. Install the new retaining clip for the rear brake hose.
3. Position the rear brake hose on the mounting bracket.
Important When installing the mounting bolt to the brake hose or brake lines, always finger-tighten the bolt before tightening to specification.
4. Install the mounting bolt.
^
Tighten the mounting bolt to 19 Nm (14 ft. lbs.).
5. Remove the rubber plug or cap from the left brake line to the brake hose.
Important When installing the brake hose or brake line fittings, always finger-tighten the fitting before tightening to specification.
