Colorado 4WD L5-3.5L VIN 6 (2005)
10.
Remove fixture EN 45680-401, cylinder bore sleeve puller EN 45680-402, and the cylinder bore sleeve (117) from the engine block.
11.
Loosen the nut (1) in order to remove the cylinder bore sleeve (117).
12.
Inspect the cylinder bore in the cylinder block for cracks or damage. If cracked or damaged, replace the cylinder block.
13.
Inspect the piston, piston rings, and connecting rod for damage. Refer to Piston, Connecting Rod, and Bearings Cleaning and Inspection.
Cylinder Bore Sleeve Installation
Note:
Do not use assembly aids or lubricants on the cylinder bore sleeve or the cylinder bore block when installing a new cylinder bore sleeve, or
engine damage will occur. These items will not aid in the installation of the new cylinder bore sleeve.
Note:
Do not chill or heat the cylinder bore sleeve or the cylinder block when removing or installing a new cylinder bore sleeve. Chilling or heating
the cylinder bore sleeve or the cylinder block will cause engine damage and will not aid the removal or installation of the new cylinder bore
sleeve.
1.
Place the NEW cylinder bore sleeve (117), P/N 88984239, onto the cylinder block.
