Colorado 4WD L5-3.5L VIN 6 (2005)
The trim tool cutter with the new trimmer pilot can be viewed from the bottom of the tool. Refer to the illustration above.
1.
After installing the NEW cylinder bore sleeve(s) into the engine block, trim the excess material from the cylinder bore sleeve flange.
2.
Place metal shaving catch plug EN 45680-413 into the cylinder bore sleeve to be trimmed. Position the top of the EN 45680-413 approximately
3.0 mm (0.12 in) below the top surface of the cylinder bore sleeve.
3.
Place additional metal shaving catch plugs EN 45680-413 into all remaining cylinder bore sleeves.
