Colorado 4WD L5-3.5L VIN 6 (2005)
Most P-metric tire sizes do not have exact corresponding alphanumeric tire sizes. Replacement tires should be of the same Tire Performance Criteria
(TPC) specification number including the same size, the same load range, and the same construction as those originally installed on the vehicle.
Consult a tire dealer if you must replace the P-metric tire with other sizes. Tire companies can best recommend the closest match of alphanumeric to
P-metric sizes within their own tire lines.
Replacement Wheels Description
Replace the wheel if any of the following conditions exist:
^
The wheel exhibits excessive runout.
^
The wheel is bent.
^
The wheel is cracked.
^
The wheel is severely rusted.
^
The wheel is severely corroded.
Important: Air leaks caused by porosity on aluminum wheels are repairable. The wheel leaks air.
Caution: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment
parts. Installation of used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle
handling and loss of vehicle control resulting in personal injury.
Notice: The use of non-GM original equipment wheels may cause:
^
Damage to the wheel bearing, the wheel fasteners and the wheel
^
Tire damage caused by the modified clearance to the adjacent vehicle components
^
Adverse vehicle steering stability caused by the modified scrub radius
^
Damage to the vehicle caused by the modified ground clearance
^
Speedometer and odometer inaccuracy
Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if applicable, if any of the following conditions exist:
^
The wheel has elongated bolt holes.
^
The wheel/nuts, or bolts if applicable, loosen repeatedly.
Steel wheel identification is stamped into the wheel near the valve stem.
Aluminum wheel identification is cast into the inboard side of the wheel.
