Colorado 4WD L5-3.5L VIN 6 (2005)
3. Install the 2 fasteners retaining the BCM to the hinge pillar.
4. Install the fastener retaining the body wiring harness electrical connector to the BCM.
5. Connect the I/P wiring harness electrical connector (1) to the BCM.
6. Connect the body wiring harness electrical connector (1) to the BCM.
7. Install the right front hinge pillar trim panel.
8. If installing a replacement BCM, program the BCM. Refer to Control Module References. See: Testing and Inspection/Programming and
Relearning
