Colorado 4WD L5-3.5L VIN 6 (2005)
2.
Install the steering gear RH isolator bracket.
3.
Loose install the steering gear horizontal mounting nuts, the washers and the bolts.
Note:
Refer to Fastener Notice in Cautions and Notices.
4.
On 4WD vehicles, install the drivers side carrier mounting bracket-to-frame bolts.
Tighten the bolts to 152 N.m (112 lb-ft).
5.
Remove the front carrier support.
6.
Install the crossmember, 2WD ONLY.
7.
Loose install the steering gear vertical mounting nuts, the washers and the bolts.
