Colorado 4WD L5-3.5L VIN 6 (2005)
Constant Velocity Joint Boot: Service and Repair
Outer
Wheel Drive Shaft Outer Joint and Boot Replacement
Tools Required
-
J 35910 Drive Axle Seal Clamp Plier
-
J 8059 Snap Ring Pliers
Removal Procedure
Important: When replacing the outer seal you MUST replace the inner seal.
1. Remove the inner seal.
Important: Do not damage the outer race while using the hand grinder.
2. Use a hand grinder to cut through the large retaining clamp (3) located at the C/V joint (4).
Discard the large retaining clamp.
3. Use a hand grinder to cut through the small retaining clamp (1) on the small end of the outer seal (2).
Discard the small retaining clamp.
Important: Do NOT remove the C/V joint from the driveshaft bar. If the C/V joint is removed from the driveshaft bar you must replace the
whole driveshaft assembly.
4. Remove the outer seal (1) from the C/V joint (2).
Slide the outer seal (1) away from the C/V joint (2) and remove from the driveshaft bar.
Discard the outer seal.
5. Clean the old grease out of the C/V joint and allow to thoroughly dry.
Installation Procedure
