Colorado 4WD L5-3.5L VIN 6 (2005)
Gear Sensor/Switch: Service and Repair
Transfer Case Encoder Motor Replacement
Transfer Case Encoder Motor Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the following from the encoder motor (7):
^
The electrical connector (8)
^
The vent hose
3. Remove the encoder motor mounting bolts.
4. Remove the encoder motor (3) and O-ring seal (2) from the transfer case. Discard the O-ring seal (2).
Installation Procedure
Important:
^
The actuator shaft in the transfer case may require rotating to the neutral position prior to installing the encoder motor.
^
Do not rotate the actuator shaft using the encoder motor.