Colorado 4WD L5-3.5L VIN 6 (2005)
1. Lightly lubricate the NEW O-ring seal (2) with clean transfer case fluid.
2. Insert the O-ring seal (2) into the transfer case.
3. Important: Ensure the encoder motor is seated flat against the transfer case.
Position the encoder motor (3) to the transfer case , aligning the actuator shaft.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the encoder motor mounting bolts, with the heated oxygen sensor bracket (1).
Tighten the encoder motor mounting bolts to 22 Nm (16 ft. lbs.).
5. Connect the following to the encoder motor (7):
^
The electrical connector (8)
^
The vent hose
6. Lower the vehicle.
