Colorado 4WD L5-3.7L (2007)
Installation Procedure
1. Position the grille to the grille molding.
2. Using a Weller(R) model 8200 soldering gun, or equivalent, equipped with a flat tip, use a circular motion around the heat stake. Apply firm
steady pressure to spread the heat stake material onto the grille panel to achieve a proper weld. Heat stake the grille to the grille molding at all heat
stake locations.
3. Install the grille bar.
Notice: Refer to Fastener Notice .
4. Install the grille bar retaining nuts.
Tighten the nuts to 4 N.m (35 lb in).
