Colorado 4WD L5-3.7L (2007)
The sunroof window must be in the full open position to do the following:
1. Unhook the wind deflector slide blocks (1) from each side.
2. Unhook the wind deflector tabs (2) from the center of the upper frame.
3. Remove the wind deflector.
13. IMPORTANT: Mark the left and right sides of the guides in respect to the frame. This will assist in the alignment of the window to the module
later.
Note the location of the bolts, size and color when removing, for proper installation.
Remove the two screws (1) on each side of the guides (2).
14. IMPORTANT: Place the sunroof module on a flat protective cover, face down. It is necessary to slide the guides about 1 cm (1 3/8 in) rearward
to release the upper frame.
