Colorado 4WD L5-3.7L (2007)
Important: Note the orientation of the wheel speed sensor harness to the steering knuckle to ensure correct installation.
3. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the steering knuckle.
4. Remove the wheel hub/bearing bolts (1).
5. Remove the brake rotor (2) and the wheel hub/bearing as an assembly from the steering knuckle (3) while routing the wheel speed sensor harness
through the steering knuckle.
6. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the wheel hub/bearing assembly.
Important: DO NOT lever or pry against the wheel speed sensor tone wheel under the wheel speed sensor. Lever against the wheel hub
ONLY.
7. Using a suitable tool, pry or lever the wheel speed sensor off of the wheel hub/bearing housing.
Discard the wheel speed sensor.
Installation Procedure
